Sunday , August 25th 2019
    Knitting and Sewing Equiptment

Manual Industrial Shoe Making Sewing Machine Equipment Shoes Repairs Sewing

Product Features:

    Operating Instructions: 1. Preparation before operation: * Press the foot and avoid the friction between the foot and the pin plate. * Check the fastening of fixed screws in each department. * Add oil to each part of the oil. * The shaking guide plate can be used without…
Price as on: 2019-07-24 19:56:40
159.9  

Product Description

Operating Instructions:
1. Preparation before operation:
* Press the foot and avoid the friction between the foot and the pin plate.
* Check the fastening of fixed screws in each department.
* Add oil to each part of the oil.
* The shaking guide plate can be used without the sound of kazak.
2. Shake the guide plate, lift the needle to the highest position, remove the shuttle with tweezers, lift and push the needle plate, and remove the shuttle with tweezers.
3. Pull off the winding machine, pull out the wire wrap around the center of the spindle for a few weeks into the spool, shake the guide plate to be wrapped around the center of the shuttle, and pull back the winding.
4. The center of the shuttle will first transmit the thread of the spindle to the line hole of the shuttle money, and then insert the spindle into the shuttle, and then the thread will be inserted into the hole of the surface to pull the line.
5.Put the position of the spindle is hand guide plate, the needle was about to rise, the spindle end to aim at the needle groove, and the thread take 2 to 3 inches long, according to the bed and a half months have flown groove close needle plate again, shaking the market, but the bottom line to the needle plate, passed quickly put the location of the error, the bottom line with online and offline.
6.Shake the guide plate, lift the needle to the top position, and put down the foot. Pull out the line head in the coil, thread through the middle shaft, through the thread and line, through the thread spring and thread, enter the hole of the needle, and then pull the line through the needle hole to pull the line head 2-3 inches.
7. Leave the front of the line in the left hand (not too tight), and use the right hand to shake the guide plate, so that the needle belt line will pass through the pin hole to draw the bottom line, and together with the bottom line, the machine press the foot gap left behind.

Product Features

  • This machine can only be used with nylon line, sewing thickness is 3mm and thick of line 0.2mm,the needle need number 14 to 20.The distance between the needles can be regulated, and the width is about 0.25-0.33cm.
  • Can sewing different material shoe by nylon or cotton wire.(Such as cloth shoes , rubber shoes , leather shoes , sneakers , high heels , as well as raincoats , leather bags , cloth , trousers, or other leather products.
  • The walking foot works well, and being able to sew in any direction by turning the foot is really handy.It uses standard sewing machine needles.Need to set it up by yourself, the assembly is straightforward and simple.
  • Mending shoes machine parts need to go once a day, can guarantee the machine running light, no noise, especially the shuttle tank must be in a bobbin, add oil, lest produce pist and wear and tear, improve work efficieancy, prolong service life.
  • Noteļ¼šIn order to prevent the machine from rusting, we will wipe some oil on it.Need to refill the active parts of refueling machine once a day, to ensure that the machine running light, no noise, improve work efficiency, extend the service life.